How To Attach An Ipv6 Source Guard Policy To A Layer 2 Etherchannel Interface - Cisco Catalyst 2960 series Configuration Manual

Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs Also See for Catalyst 2960 series:
Table of Contents

Advertisement

Command or Action
Step 3
interface Interface_type stack/module/port
Example:
Switch(config)#
Step 4
ipv6 source-guard [attach-policy <policy_name> ]
Example:
Switch(config-if)# ipv6 source-guard attach-policy
example_policy
Step 5
show ipv6 source-guard policy policy_name
Example:
Switch#(config-if)# show ipv6 source-guard policy
example_policy
Related Topics
Information about First Hop Security in IPv6, on page 678

How to attach an IPv6 Source Guard Policy to a Layer 2 EtherChannel Interface

SUMMARY STEPS
1. enable
2. configure terminal
3. interface port-channel port-channel-number
4. ipv6 source-guard [attach-policy <policy_name> ]
5. show ipv6 source-guard policy policy_name
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch> enable
interface gigabitethernet 1/1/4
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure IPv6 Source Guard
Purpose
Specifies an interface type and identifier; enters the
interface configuration mode.
Attaches the IPv6 Source Guard policy to the interface.
The default policy is attached if the attach-policy option
is not used.
Shows the policy configuration and all the interfaces
where the policy is applied.
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
707

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents