Provisioning A New Member For A Switch Stack - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Step 4
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 5
reload
Example:
Switch# reload

Provisioning a New Member for a Switch Stack

This optional task is available only from the active switchstack master.
SUMMARY STEPS
1. show switch
2. configure terminal
3. switch stack-member-number provision type
4. end
5. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 show switch
Example:
Switch# show switch
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3 switch stack-member-number provision type
Example:
Switch(config)# switch 3 provision WS-xxxx
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Purpose
(Optional) Saves your entries in the configuration
file.
Reloads the switch stack.
Purpose
Displays summary information about the switch stack.
Enters global configuration mode.
Specifies the stack member number for the preconfigured switch.
By default, no switches are provisioned.
For stack-member-number, the range is 1 to 8. Specify a stack
member number that is not already used in the switch stack. See
Step 1.
How to Configure a Switch Stack
739