How To Configure Auto-Qos - Cisco Catalyst 2960 series Configuration Manual

• When you reload the switch, the system detects and re-executes the saved auto-QoS commands and the
Do not make changes to the auto-QoS-generated commands when auto-QoS compact is enabled, because
Note
user-modifications are overridden when the switch reloads.
When auto-qos global compact is enabled:
• show derived-config command can be used to view hidden AQC derived commands.
• AQC commands will not be stored to memory. They will be regenerated every time the switch is reloaded.
• When compaction is enabled, auto-qos generated commands should not be modified .
• If the interface is configured with auto-QoS and if AQC needs to be disabled, auto-qos should be disabled

How to Configure Auto-QoS

Configuring Auto-QoS
Enabling Auto-QoS
For optimum QoS performance, enable auto-QoS on all the devices in your network.
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. Use one of the following:
4. exit
5. interface interface-id
6. auto qos trust
7. end
8. show auto qos interface interface-id
AutoQoS SRND4.0 compliant config-set is generated .
at interface level first.
• auto qos voip {cisco-phone | cisco-softphone | trust}
• auto qos video {cts | ip-camera | media-player}
• auto qos classify [police]
• auto qos trust {cos | dscp}
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure Auto-QoS
651