Specifying Vlans To Filter - Cisco Catalyst 2960 series Configuration Manual

How to Configure SPAN and RSPAN
Command or Action
Step 5
monitor session session_number destination
remote vlan vlan-id
Example:
Switch(config)# monitor session 1
destination remote vlan 100
Step 6
end
Example:
Switch(config)# end
Step 7 show running-config
Example:
Switch# show running-config
Step 8
copy running-config startup-config
Example:
Switch# copy running-config
startup-config
Related Topics
Remote SPAN, on page 475
RSPAN VLAN, on page 481
RSPAN Configuration Guidelines, on page 483

Specifying VLANs to Filter

Follow these steps to configure the RSPAN source session to limit RSPAN source traffic to specific VLANs.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
494
Purpose
◦tx—Monitors sent traffic.
Specifies the RSPAN session, the destination RSPAN VLAN, and the
destination-port group.
• For session_number, enter the number defined in Step 4.
• For vlan-id, specify the source RSPAN VLAN to monitor.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.