Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

SUMMARY STEPS
1. enable
2. configure terminal
3. mvr
4. mvr group ip-address [count]
5. mvr querytime value
6. mvr vlan vlan-id
7. mvr mode {dynamic | compatible}
8. end
9. Use one of the following:
10. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 mvr
Example:
Switch (config)# mvr
Step 4 mvr group ip-address [count]
Example:
Switch(config)# mvr group
228.1.23.4
• show mvr
• show mvr members

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

Purpose
Enables privileged EXEC mode. Enter your password if prompted.
Enters the global configuration mode.
Enables MVR on the switch.
Configures an IP multicast address on the switch or use the count parameter
to configure a contiguous series of MVR group addresses (the range for
count is 1 to 256; the default is 1). Any multicast data sent to this address
is sent to all source ports on the switch and all receiver ports that have
elected to receive data on that multicast address. Each multicast address
would correspond to one television channel.
To return the switch to its default settings, use the no mvr [mode
Note
| group ip-address | querytime | vlan] global configuration
commands.
How to Configure IGMP Snooping and MVR
147