Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

Information About NetFlow Lite
Table 53: Match Parameters
Command
match datalink {ethertype | mac {destination
address input | source address input}}
match ipv4 {destination {address} | protocol |
source {address} | tos}
match ipv6 {destination {address} | flow-label |
protocol | source {address} | traffic-class}
match transport {destination-port | source-port}

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

514
Purpose
Specifies a match to datalink or Layer 2 fields. The
following command options are available:
• ethertype—Matches to the ethertype of the
packet.
• mac—Matches the source or destination MAC
address from packets at input.
When a datalink flow monitor is assigned to
Note
an interface or VLAN, it only creates flows
for non-IPv6 or non-IPv4 traffic.
Specifies a match to the IPv4 fields. The following
command options are available:
• destination—Matches to the IPv4 destination
address-based fields.
• protocol—Matches to the IPv4 protocols.
• source—Matches to the IPv4 source address
based fields.
• tos—Matches to the IPv4 Type of Service
fields.
Specifies a match to the IPv6 fields. The following
command options are available:
• destination—Matches to the IPv6 destination
address-based fields.
• flow-label—Matches to the IPv6 flow-label
fields.
• protocol—Matches to the IPv6 payload protocol
fields.
• source—Matches to the IPv6 source address
based fields.
• traffic-class—Matches to the IPv6 traffic class.
Specifies a match to the Transport Layer fields. The
following command options are available:
• destination-port—Matches to the transport
destination port.
• source-port—Matches to the transport source
port.