Example: Configuring A Host Statically To Join A Group - Cisco Catalyst 2960 series Configuration Manual

Configuration Examples for IGMP Snooping and MVR

Example: Configuring a Host Statically to Join a Group

This example shows how to statically configure a host on a port:
Switch#
Switch#
Switch#
Related Topics
Configuring a Host Statically to Join a Group , on page 133
Joining a Multicast Group, on page 119
Example: Enabling IGMP Immediate Leave
This example shows how to enable IGMP Immediate Leave on VLAN 130:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 130 immediate-leave
Switch(config)# end
Related Topics
Enabling IGMP Immediate Leave , on page 135
Immediate Leave , on page 121
Example: Setting the IGMP Snooping Querier Source Address
This example shows how to set the IGMP snooping querier source address to 10.0.0.64:
Switch# configure terminal
Switch(config)# ip igmp snooping querier 10.0.0.64
Switch(config)# end
Related Topics
Configuring the IGMP Snooping Querier , on page 142
IGMP Snooping, on page 118
Example: Setting the IGMP Snooping Querier Maximum Response Time
This example shows how to set the IGMP snooping querier maximum response time to 25 seconds:
Switch# configure terminal
Switch(config)# ip igmp snooping querier query-interval 25
Switch(config)# end
Related Topics
Configuring the IGMP Snooping Querier , on page 142
IGMP Snooping, on page 118
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
162
configure terminal
ip igmp snooping vlan 105 static 224.2.4.12 interface gigabitethernet1/0/1
end