How To Configure The Ipv6 Binding Table Content - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Step 2
interface range Interface_name
Example:
Switch(config)#
Step 3
ipv6 snooping [attach-policy policy_name [ vlan {vlan_ids |
add vlan_ids | except vlan_ids | none | remove vlan_ids | all}
] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none |
remove vlan_ids | all} ]
Example:
Switch(config-if-range)# ipv6 snooping attach-policy
example_policy
or
Switch(config-if-range)# ipv6 snooping attach-policy
example_policy vlan 222,223,224
or
Switch(config-if-range)#ipv6 snooping vlan 222,
223,224
Step 4 do show running-config interfaceportchannel_interface_name
Example:
Switch#(config-if-range)#
int po11
Related Topics
Information about First Hop Security in IPv6, on page 678
Information about First Hop Security in IPv6, on page 678

How to Configure the IPv6 Binding Table Content

Beginning in privileged EXEC mode, follow these steps to configure IPv6 Binding Table Content :
interface Po11
do show running-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure the IPv6 Binding Table Content
Purpose
Specify the port-channel interface name assigned when
the EtherChannel was created. Enters the interface range
configuration mode.
Enter the do show interfaces summary command
Tip
for quick reference to interface names and types.
Attaches the IPv6 Snooping policy to the interface or the
specified VLANs on that interface. The default policy is
attached if the attach-policy option is not used.
Confirms that the policy is attached to the specified
interface without exiting the configuration mode.
685