Enabling Vlan-Based Qos On Physical Ports - Cisco Catalyst 2960 series Configuration Manual

How to Configure QoS
Command or Action
startup-config
Related Topics
Standard QoS Default Configuration, on page 563
Default Egress Queue Configuration, on page 565
Default Ingress Queue Configuration, on page 564

Enabling VLAN-Based QoS on Physical Ports

By default, VLAN-based QoS is disabled on all physical switch ports. The switch applies QoS, including
class maps and policy maps, only on a physical-port basis. You can enable VLAN-based QoS on a switch
port.
The following procedure is required on physical ports that are specified in the interface level of a hierarchical
policy map on a Switch Virtual Interface (SVI).
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. mls qos vlan-based
4. end
5. show mls qos interface interface-id
6. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 interface interface-id
Example:
Switch(config)# interface
gigabitethernet 1/0/1
Step 3 mls qos vlan-based
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
572
Purpose
Purpose
Enters global configuration mode.
Specifies the physical port, and enter interface
configuration mode.
Enables VLAN-based QoS on the port.