How To Attach An Ipv6 Snooping Policy To A Layer 2 Etherchannel Interface - Cisco Catalyst 2960 series Configuration Manual

How to Configure an IPv6 Snooping Policy
Command or Action
Switch(config-if)# ipv6 snooping
attach-policy example_policy
or
Switch(config-if)# ipv6 snooping vlan
111,112
or
Switch(config-if)# ipv6 snooping
attach-policy example_policy vlan 111,112
Step 5
do show running-config
Example:
Switch#(config-if)# do show running-config
Related Topics
Information about First Hop Security in IPv6, on page 678

How to Attach an IPv6 Snooping Policy to a Layer 2 EtherChannel Interface

Beginning in privileged EXEC mode, follow these steps to attach an IPv6 Snooping policy on an EtherChannel
interface or VLAN:
SUMMARY STEPS
1. configure terminal
2. interface range Interface_name
3. ipv6 snooping [attach-policy policy_name [ vlan {vlan_ids | add vlan_ids | except vlan_ids | none |
remove vlan_ids | all} ] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none | remove vlan_ids |
all} ]
4. do show running-config interfaceportchannel_interface_name
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
684
Purpose
Verifies that the policy is attached to the specified interface without
exiting the interface configuration mode.
Purpose
Enters the global configuration mode.