Verifying Per Vrf For Tacacs Servers - Cisco Catalyst 2960 series Configuration Manual

How to Configure TACACS+
Command or Action
Step 13
ip tacacs source-interface subinterface-name
Example:
Device(config-sg-tacacs+)# ip tacacs
source-interface Loopback0
Step 14 exit
Example:
Device(config-sg-tacacs)# exit

Verifying Per VRF for TACACS Servers

To verify the per VRF TACACS+ configuration, perform the following steps:
The debug commands may be used in any order.
Note
SUMMARY STEPS
1. enable
2. debug tacacs authentication
3. debug tacacs authorization
4. debug tacacs accounting
5. debug tacacs packets
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 debug tacacs authentication
Example:
Device# debug tacacs authentication
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
894
Purpose
Uses the IP address of a specified interface for all
outgoing TACACS+ packets.
Exits server-group configuration mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Displays information about AAA/TACACS+
authentication.