Local Span - Cisco Catalyst 2960 series Configuration Manual

Information About SPAN and RSPAN
being monitored, traffic that gets routed from another VLAN to the source VLAN cannot be monitored;
however, traffic that is received on the source VLAN and routed to another VLAN can be monitored.
You can use the SPAN or RSPAN destination port to inject traffic from a network security device. For example,
if you connect a Cisco Intrusion Detection System (IDS) sensor appliance to a destination port, the IDS device
can send TCP reset packets to close down the TCP session of a suspected attacker.

Local SPAN

Local SPAN supports a SPAN session entirely within one switch; all source ports or source VLANs and
destination ports are in the same switch or switch stack. Local SPAN copies traffic from one or more source
ports in any VLAN or from one or more VLANs to a destination port for analysis.
All traffic on port 5 (the source port) is mirrored to port 10 (the destination port). A network analyzer on port
10 receives all network traffic from port 5 without being physically attached to port 5.
Figure 45: Example of Local SPAN Configuration on a Single Device
This is an example of a local SPAN in a switch stack, where the source and destination ports reside on different
stack members.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
474