12-961 Mix Full Stack
•
Compared to the maximum paper size that was loaded at the previous job, the paper size
(either feed direction or width direction) of the next job is bigger.
•
Staple mode has been changed while the width of the maximum paper size that was
loaded at the previous job is less than 279.4mm.
•
The maximum paper size that was loaded at the previous job is unknown.
Procedure
Remove the Finisher Front Cover. Enter
Sensor
(Figure
1). The display changes.
Y
N
Press Stop. Check the circuit of the Stack A Sensor
for troubleshooting procedure.
Enter
dC330
[012-205] and press Start. Actuate the Stack B Sensor. The display changes.
Y
N
Press Stop. Check the circuit of the Stack B Sensor
for troubleshooting procedure.
Enter
dC330
[012-200] and press Start. Actuate the Stacker Paper Sensor. The display
changes.
Y
N
Press Stop. Check the circuit of the Stacker Paper Sensor
2
RAP for troubleshooting procedure.
Press Stop. Rotate the Stacker Motor Drive Pulley manually by turning the Stacker Drive
Motor Drive Gear
(PL
17.11). The pulley rotates smoothly.
Y
N
Check the following and repair the Stacker Drives as required
•
Stacker Motor Gear for wear and damage.
•
Stacker Tray for dragging and incorrect installation.
•
Stacker Elevator Belt/rack/gear for wear and damage.
Disconnect Stacker Motor P/J889. Measure the resistance between pin 1 and pin 2 of the
motor connector. Between 12 to 40 ohms is measured while the pulley is rotated manu-
ally.
Y
N
Replace the Stacker Motor
(PL
17.11).
•
Ensure that the connectors shown in the circuit diagrams
Figure
5) are securely connected and that the wires are not damaged.
•
If the problem persists, replace Finisher PWB
Status Indicator RAPs
12-961
dC330
[012-204] and press Start. Actuate the Stack A
(Figure
2). Refer to the
(Figure
3). Refer to the
(Figure
4). Refer to the
(PL
17.11).
(Figure
2,
Figure
(PL
17.13)
(Figure
6).
NOTE: The large white Stacker Drive Pulley can be pulled out to release the Stacker Drives to
free the Stacker Tray
Upper
Limit
Sensor
Stack A
OF 99-2
RAP
Sensor
Stack B
Sensor
OF 99-2
RAP
OF 99-
Figure 2 12-961 RAP Circuit Diagram - Stack A Sensor
3,
Figure
4,
02/03
2-292
(REP
12.20).
Figure 1 Component Location
Stacker
Paper
Sensor
Stacker
Motor
Initial issue
DC 3535/2240/1632