Rep 9.21 Left Lift Assembly - Xerox DocuColor 2240 Service Manual

REP 9.21 Left Lift Assembly

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Front Cover (REP 14.7).
2. Remove Lever (REP 9.18).
3. Remove Rear Cover (REP 14.2).
4. Remove Left Lower Cover Assembly
5. Remove Tray 5 (REP 7.1).
6. Remove Left Cover Assembly (REP
7. Optional for improved visibility: Remove Fuser
8. Remove Registration Transport Assembly
9. Remove MOB Sensor (REP 9.14).
10. Remove Left Hinge (REP 9.19).
11. Remove Cyan and Black Toner Cartridges.
12. Remove Cyan and Black Toner Dispensers
NOTE: In next step, do not remove the Full Toner Sensor from the sensor housing
In next step, it may not be necessary to disconnect harnesses for Plate Assembly
remove a developer housing.
13. Remove Plate Assembly (REP 9.8).
14. Remove Cyan and Black Developer Housings
15. Remove Left Lift Assembly (Figure
NOTE: In next step, use a magnet to capture E-Ring and Washer while removing them.
a. From inside Developer Housing cavity, remove e-ring and washer from each end of
Left Lift.
b. Remove screws (4).
c. Remove Left Lift Assembly.
NOTE: Maintain orientation to ensure bearings (2) and washers (2) do not fall off
posts.
Initial issue
DC 3535/2240/1632
WARNING
(REP 14.6).
8.1).
(REP 10.1).
(REP 8.6).
(REP 9.7).
(REP 9.9).
1).
(PL 4.2) to
Replacement
1. Install Lift Assembly.
a. Position Lift Assembly in frame.
b. Raise or lower xerographic frame as required and push in or pull out Lift Assembly
actuator as required to engage lift bearings with slots in xerographic frame.
c. Install front top screw, then front bottom screw, then rear screws (2).
d. Install washers (2) and e-rings (2).
2. Assemble remaining machine components.
02/03
4-87
Bearing
Washer
Screws (2)
Washer
E-Ring
Screws (2)
Figure 1 Removing Left Lift Assembly
E-Ring
Repairs and Adjustments
REP 9.21