8-176 Registration Sensor On Jam Tray 1-4
The Registration Sensor does not detect paper fed from Tray 1 - 4.
Initial Actions
•
Ensure customer closes Left Lower Cover
•
Check condition and specification of the paper supply.
•
Check for obstructions in the paper feed path
•
Clean the Takeaway Roll and Pinch Roll and check for wear.
•
Check the drive transmissions for damage or wear.
Procedure
Open the Left Cover Assembly
(PL
2.9) Enter
unblock the Registration Sensor. The display changes state.
Y
N
Press Stop. Check the circuit of the Registration Sensor
RAP for troubleshooting procedure.
Close the Left Cover Assembly and press Stop. Enter
Takeaway Clutch
(PL
1.2) energizes.
Y
N
Press Stop. Check the circuit of the Takeaway Clutch
RAP for troubleshooting procedure.
Press Stop.
•
Ensure that the Chute
(PL
2.3) is properly seated and not damaged.
•
Check the Pinch Rolls
(PL
2.3) for damage or contamination.
•
Ensure that the connectors shown in the circuit diagrams
connected and that the wires are not damaged.
•
Replace the Registration Sensor
(PL
•
If the problem persists, replace the ESS PWB
Figure 1 8-176 RAP Circuit Diagram - Registration Sensor
Status Indicator RAPs
8-176
(PL
2.3) firmly if dog ears also occur.
dC330
[008-104] and press Start. Block and
(Figure
1). Refer to the
dC330
[008-038] and press Start. The
(Figure
2). Refer to the
(Figure
1,
Figure
2) are securely
2.6).
(PL
13.1).
Figure 2 8-176 RAP Circuit Diagram - Takeaway Clutch
OF 99-1
OF 99-4
02/03
2-160
Initial issue
DC 3535/2240/1632