740--Xxx Iot Manager Nvm List; 741--Xxx Drive Nvm List - Xerox DocuColor 2240 Service Manual

740--xxx IOT Manager NVM List

Chain-Link Name
740-020 Market Code
740-024 RegiCon Request Flag
740-025 Edge Check Request Flag
740-026 ProCon Request Flag
740-027 Temperature when act RegiCon
740-028 Date when act PowerOn-SetUp or
NextDay-SetUp
740-028 Date when act PowerOn-SetUp or
NextDay-SetUp
740-029 Power Off Delay Switch

741--xxx Drive NVM List

Chain-Link Name
741-054 NVM_PR_MOT_HIGH_PULSE (PR
2240/1632 (Drum) Motor Speed Fine Adjustment
only (Standard)
741-055 NVM_PR_MOT_LOW_PULSE (PR
2240/1632 (Drum) Motor Speed Fine Adjustment
only (Heavy Weight /Transparency)
741-056 Belt Home Fail Too Long counter
741-057 NoPaperRun Mode SW
741-068 NVM_PR_MOT_DOUBLE_PULSE (PR
2240/1632 (Drum) Motor Speed Fine Adjustment
only (Double Speed)
741-111 Belt Length Variable
741-112 IBT Motor Reverse Switch
3535 only
741-113 PR Motor Reverse Switch
3535 only
741-114 Reverse time
3535 only
741-115 Threshold for PV Counter
3535 only
741-113 PV Counter for Drive
3535 only
General Procedures and Information
740--xxx IOT Manager NVM List, 741--xxx Drive NVM
Table 1 Chain 740
Default Range Description
XC=2; XE=3 - XC=2; XE=3
0 0~255 0=Performed; 1=Not performed
0 0~255 0=Performed; 1=Not performed
0 0~255 0=Performed; 1=Not performed
0 0~255 20 degrees C/ bit
0 0~255
0 0~255
0 0~1 0=Delay on; 1=Delay off
Table 1 Chain 741
Default Range Description
23 0~40 Performs fine adjustment of Drum speed at standard speed. Each bit raises or lowers the drum speed by
approx. 0.05% with respect to the initial value.
23 0~40 Fine adjusts the Drum speed at half speed. Each bit raises or lowers the drum speed by approx. 0.05% with
respect to the initial value.
0 0~3 It is necessary to reset the counter to reenable operation if the value reaches 3.
0 0~2 0=Normal NoPaperRun 1=MainMotor Stop 2=Main/Dev. Motor Stop
22 0~40 Fine adjusts the Drum Speed at double speed. Increases the Drum Speed by +1 (approx. 0.05%) with respect
to the initial value. Decreases the Drum Speed by -1 (approx. 0.05%).
10 0~24 Correction of belt peripheral length for lead registration (0.2544 mm/bit)
1 0~1 Switch to reverse IBT Motor rotation at job end
0=Disable; 1=Enable
0 0~1 Switch to reverse PR Motor rotation at job end
0=Disable; 1=Enable
13 12~25 Time from the reverse rotation-start signal until the reverse rotation-disabling signal (10 msec/bit)
IBT: Time of step-up + constant speed
PR: Time from On to Off of Reverse rotation port
(Excluding time of step-down and stop)
200 1~65535 Reverse rotation interval by PV
0 0~65535 Total PV from the previous reverse rotation
02/03
6-22
Initial issue
DC 3535/2240/1632