Rep 6.11 Carriage Cables - Xerox DocuColor 2240 Service Manual

REP 6.11 Carriage Cables

Parts List on PL 18.5
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
NOTE: This page describes how to remove Rear Carriage Cable. The Front Carriage Cable is
replaced in the same fashion.
NOTE: Do not replace both cables at same time. Remove front and rear cables separately.
1. Remove DADF (REP 5.1).
2. Remove Platen Glass (REP 6.2).
3. Remove IIT Top Cover (REP 6.3).
4. Remove Registration Gate and Plate
1
Remove
Registration
Gate Screws
(2)
Figure 1 Removing Registration Gate and Plate
5. Remove Full Rate Carriage from IIT Frame
tor connected.
Repairs and Adjustments
REP 6.11
WARNING
(Figure 1).
3
4
Remove Plate
Remove
Screws (2)
Plate
2
Remove Registration
Gate
(REP 6.14). Keep lamp wire harness connec-
6. Position the Carriage Cable Ball so that it is directly at the top of the Capstan
Verify that there are 2.5 Carriage Cable windings on both sides of the Ball.
Figure 2 Positioning Half Rate Carriage
02/03
4-44
Carriage Cable
Ball
Carriage Cable
Windings
DC 3535/2240/1632
(Figure 2).
Initial issue