Rep 9.8 Plate Assembly - Xerox DocuColor 2240 Service Manual

REP 9.8 Plate Assembly

Parts List on PL 4.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Front Cover (REP 14.7).
2. Remove Drum Cartridges (REP 9.1).
3. Remove Waste Toner Cartridge (REP
4. Remove Waste Toner Cartridge Cover
5. Remove Fuser Cover (REP 14.8).
6. Remove Dispenser Cover (REP 9.6).
7. Remove all Toner Dispenser (REP
Note position of harnesses. Correct harness routing is required for assembly.
NOTE: In next step, do not remove sensor.
8. Remove housing for Full Toner Sensor
Initial issue
DC 3535/2240/1632
WARNING
9.4).
(REP 9.3).
9.7).
CAUTION
(REP 9.5).
9. Disconnect Developer housing connectors, 4 large and 4 small (small not shown).
Position wires straight out from machine. Wires remain stationary while removing Plate
Assembly (Figure 1).
Developer Housing
connectors (4 Large)
Figure 1 Disconnecting Developer Housing Connectors
02/03
4-77
Repairs and Adjustments
REP 9.8