Adj 5.4 Document Transport Height - Xerox DocuColor 2240 Service Manual

ADJ 5.4 Document Transport Height

Purpose
Enable document feed at the correct speed and free of skew.
Check
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Front Cover (PL 20.1).
2. Entrance Tray (PL 20.1).
3. Check Document Transport Height
At left end of Document Transport, check that there is 24.5 ±0.3 mm between top of
a.
Document Transport Frame and Top of Rear Registration Edge.
At Right end of Document Transport, check that there is 24.5 ±0.3 mm between top
b.
of Document Transport Frame and Top of Rear Registration Edge.
c. If there is more or less than specified, perform the adjustment on the counterbalance
for the side that is not in specification. Adjust both counterbalances if required.
Otherwise, Document Transport Height is good.
Document Transport Frame
24.5 ±0.3 mm
Left End of Document Transport
Figure 1 Checking Document Transport Height
Initial issue
DC 3535/2240/1632
WARNING
(Figure 1).
Top of
Rear Reg-
istration
Edge
Right End of
Document
Transport
Adjustment
When removing the Rear Cover, disconnect LED Connector on DADF PWB.
1. Remove Rear Cover (REP 5.18).
2. Raise DADF and loosen the Screws (2)
Figure 2 Loosening Screws
02/03
4-153
CAUTION
(Figure 2).
Screws
Repairs and Adjustments
ADJ 5.4