Of 2-1 Dark / Blank Display - Xerox DocuColor 2240 Service Manual

Hide thumbs Also See for DocuColor 2240:
Table of Contents

Advertisement

OF 2-1 Dark / Blank Display

UI Display is dark with minimal legibility, or no text or graphics are visible.
Initial Actions
Ensure all external cables and power cords are connected.
Procedure
NOTE: If a Status Code is displayed, go to status code RAP.
There is some luminance in the UI display.
Y
N
Switch off the power. Listen to the cooling fans on the right side and at the rear of the
machine and switch on the power. Cooling fans are audible either momentarily or
continuously.
Y
N
There is a +5 VDC failure. Go to the
Switch off the power. Remove the Platen Glass
Switch on the power. +24 VDC is measured between P/J720-1 (+) and -5 on the IIT/
IPS PWB.
Y
N
Remove the IIT Top Cover
(REP
-5 on the IIT LVPS.
Y
N
Approximately +3.7 VDC is measured between J705-3 on the IIT LVPS and
GND.
Y
N
Go to
Flag
7. Check the wire for an open circuit. If the wire is good,
replace the ESS PWB
+5 VDC is measured between J705-4 and GND.
Y
N
Go to
Flag
1. Check the wire for an open circuit. If the wire is good,
replace the ESS PWB
AC Line Voltage is measured between P700/J2 on the IIT LVPS.
Y
N
Ensure that the AC Harness
nected properly. If ok, go to Flag 2. Check the wires for an open circuit.
Replace the IIT LVPS
(PL
Go to
Flag
3. Check the wires for an open circuit.
+24 VDC is measured between J726-A2 and -A4 on the IIT/IPS PWB.
Y
N
Replace the IIT/IPS PWB
(PL
18.3).
+3.3 VDC is measured between J726-A6 and A8.
A
Initial issue
DC 3535/2240/1632
OF 1-2
RAP.
(REP
6.2) and the IPS Cover
6.3). +24 VDC is measured between J702-1 and
(PL
13.1).
(PL
13.1).
(PL
18.4) between the IOT and the IIT is con-
18.4).
A
Y
N
Replace the IIT/IPS PWB
+5 VDC is measured between J726-A10 and -A9.
Y
N
Replace the IIT/IPS PWB
Go to
Flag
4,
Flag
5, and
are good, replace the UI Assembly
Replace the UI PWB
(PL
18.2). If the problem continues, replace the VR PWB
(PL
18.3).
02/03
2-513
(PL
18.3).
(PL
18.3).
Flag
6. Check the wires for an open or short circuit. If the wires
(PL
18.2).
Status Indicator RAPs
(PL
18.2).
OF 2-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docucolor 3535Docucolor 1632

Table of Contents