Nd Btr Retract - Xerox DocuColor 2240 Service Manual

9-343 2nd BTR Retract

The 2nd BTR did not reach the retract position.
Initial Actions
• Clean the 2nd BTR Retract Sensor
• Check the 2nd BTR gears (PL 2.8) for breakage.
Procedure
Enter dC330 [009-200]. Open the Left Cover and block and unblock the 2nd BTR Retract Sen-
sor with a piece of paper. The display changes state.
Y N
Disconnect P/J140. There is +5VDC from J140-3 to J140-1
Y N
Check the wires from P/J533
are OK, replace the I/F PWB (PL
There is +3.3VDC from J140-2 to GND.
Y N
Check the wire from P/J533-B19 on the I/F PWB to J140-2 for an open or a short
circuit to GND. If the wires are OK, replace the I/F PWB
not solved, replace the MCU PWB
Replace the 2nd BTR Retract Sensor
In sequence, enter the following: dC330
tacts and retracts.
Y N
There is +24VDC from P/J533-B9 on the I/F PWB to GND
Y N
Go to the +24 VDC Wirenets (Figure
Check the wires between P/J533 and
for opens, shorts, or loose connections. If the wires are OK, replace the 2nd BTR Retract
Motor (PL 2.9). If the problem continues, replace the MCU PWB
continues, replace the I/F PWB (PL
Check for mechanical problems preventing the movement of the assembly. Check for debris
blocking the sensor.
Initial issue
DC 3535/2240/1632
(PL 2.9) and check for damage.
(Figure 1).
on the I/F PWB to the sensor (Figure 1). If the wires
9.1).
(PL 9.1). If the problem is
(PL 13.1).
(PL 2.9).
[009-051] then dC330 [009-052]. The 2nd BTR con-
(Figure 2).
2) and troubleshoot the problem.
P/J216 (Figure 2) on the 2nd BTR Retract Motor
(PL 13.1). If the problem
9.1).
Figure 1 9-343 Rap Circuit Diagram - 2ND BTR Retract Sensor
02/03
2-175
Status Indicator RAPs
9-343