Staple Near Empty - Xerox DocuColor 2240 Service Manual

12-965 Staple Near Empty

• The Low Staple Switch detected Low Staple at Power On and Interlock Close.
• The Low Staple Switch detected Low Staple at Staple Head Close.
Procedure
Install a new Staple Cartridge loaded with staples. +5VDC measured between the Finisher
PWB P/J852-4 and ground (Figure 1).
Y N
Replace the Finisher PWB (PL 17.13).
+5VDC measured between the Stapler Assembly P/J886-2 and ground).
Y N
Check the wire between the Stapler Assembly P/J886 and the Finisher PWB
an open circuit or poor contact.
Check the wire between the Stapler Assembly P/J886 and the Finisher PWB
open circuit or poor contact.
If no problems are found, replace the Stapler Assembly
If the problem continues, replace the Finisher PWB
Figure 1 12-965 RAP Circuit Diagram - Low Staple Sensor
Status Indicator RAPs
12-965
P/J852
P/J852 for an
(PL 17.9).
(PL 17.13) (Figure 2).
for
02/03
2-294
Figure 2 Finisher PWB
DC 3535/2240/1632
Initial issue