Tray 5 Size Mismatch (Slow Scan Direction) - Xerox DocuColor 2240 Service Manual

7-954 Tray 5 Size Mismatch (Slow Scan Direction)

The paper in the slow scan direction is shorter than the specified paper size.
Procedure
The correct size paper is loaded in the Tray 5.
Y N
Load the correct size paper.
Replace the Registration Sensor (PL 2.6).
Status Indicator RAPs
7-954, 7-959
7-959 Tray 5 Paper Mismatch 1
Incorrect type of transparency detected by the OHP sensor.
Initial Actions
• Ensure that only approved transparencies (no white strip) are used.
• Check that the transparencies are oriented correctly.
• Check for obstructions and clean the OHP Sensor.
Procedure
Open the Left Cover Assembly (PL
OHP Sensor R (PL 2.6) using a plain sheet of paper. The display changes.
Y N
Press Stop. Check the circuit of the OHP Sensor
troubleshooting procedure.
Press Stop.
• Ensure that the connectors shown in the circuit diagram
nected and that the wires are not damaged.
• If the problem persists, replace the MCU PWB
Figure 1 7-959 RAP Circuit Diagram - OHP Sensor R
02/03
2-150
2.9). Enter dC330 [008-110] and press Start. Block the
(Figure 1). Refer to the
(Figure 1) are securely con-
(PL 13.1).
DC 3535/2240/1632
OF 99-1 RAP for
Initial issue