St Btr Retract - Xerox DocuColor 2240 Service Manual

9-349 1st BTR Retract

The 1st BTR did not reach the retract position.
Initial Actions
• Clean the 1st BTR Retract Sensor (PL
• Check the 1st BTR Worm Gear and Retract Shaft
Procedure
In sequence, enter the following: dC330 [009-054] then dC330 [009-055]. The 1st BTR con-
tacts and retracts.
Y N
There is +24VDC from P/J533-A16 on the I/F PWB to GND
Y N
Go to the +24 VDC Wirenets (Figure
A B
Initial issue
DC 3535/2240/1632
5.4) and check for damage.
(PL 5.4) for breakage.
(Figure 2).
2) and troubleshoot the problem.
Figure 1 9-349 Rap Circuit Diagram - 1ST BTR Retract Sensor
A B
Check the wires between P/J533
opens, shorts, or loose connections. If the wires are OK, replace the 1st BTR Retract
Motor (PL 5.4). If the problem continues, replace the MCU PWB
continues, replace the I/F PWB
Stack dC330 input codes [004--014] (1st BTR Retract Sensor Power) and [009-203] (1st BTR
Retract Sensor). Then, in sequence, enter the following:
055]. The 1st BTR Retract Sensor changes state.
Y N
Go to Figure 1.Check the circuit of the 1st BTR Retract Sensor
Replace the MCU PWB (PL 13.1).
02/03
2-179
and P/J237 (Figure 2) on the 1st BTR Retract Motor for
(PL 13.1). If the problem
(PL 9.1).
dC330 [009-054] then dC330 [009-
(PL 5.4).
Status Indicator RAPs
9-349