Ram Disk Full Error - Xerox Phaser 6128MFP Service Manual

Error Messages and Codes

RAM Disk Full Error

Applicable Error
Initial Actions
3-92
RAM Disk memory is full and cannot receive additional data. Print job requires
additional memory. The following troubleshooting procedure applies to this error.
• 016-982: RAM Disk Full Error
• Reseat installed memory.
• Install additional memory
• Resize the RAM Disk to hold larger files.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL10.6.6
Memory Card, PL10.6.8
Troubleshooting Procedure Table
Step Actions and Questions
1 Print a small size file (example as a
Windows test print).
Does the error persist?
2 Print the Configuration Page:
System > Information Pages >
Configuration.
Does the memory amount listed
match the installed memory?
3 Replace the memory card
Does the error still occur?
Wiring and Plug/Jack Map References
Yes No
Go to step 2. Add memory,
resize the RAM
Disk, or
partition the
print job.
Replace the Reseat the
Image Memory Card
Processor Board and reprint the
(page 8-41). Configuration
page to check
memory.
Replace the Complete.
Image
Processor Board
(page 8-41).
Phaser 6128MFP Service Manual