Adj 9.9 Iot Registration Series (Dc129) - Xerox DocuColor 2240 Service Manual

Table 3 Diagnostic Routines
Diag Type Details
HDD Read Verifica- Perform the Read verify diagnostics of all the sectors in designated
tion partitions. Sector numbers where a read error is occurring will
appear.
HDD Diagnostic Perform the hard disk ROM check and controller diagnostics.
HDD Error Table Init Initialize the Error Table.
6. Press Start.
Repairs and Adjustments
ADJ 9.8, ADJ 9.9

ADJ 9.9 IOT Registration Series (dC129)

Purpose
The purpose is to adjust the position of the printed image on the page. This is done by chang-
ing the value in the appropriate NVM location in dC129. This controls where the ROS writes
the image.
Introduction
This series consists of 4 procedures:
Lead Edge Registration (Trays 1-4)
Side Edge Registration (Trays 1-5)
Duplex (Side 2) Registration
Lead Edge Registration for Tray 5
All procedures must be checked.
Lead Edge Registration (Paper Trays 1 - 4)
Purpose
To correctly set the lead edge of the image in relation to the edge of the paper. There is one
lead edge setting for Trays 1 - 4.
Check
1. Connect the PWS to the machine and enter Diagnostic Mode (refer to
Mode using the PWS). Select dC129 from the DC Quick menu
2. Load Tray 1 with the largest paper used by the customer.
3. Select ALL in the Lead Edge column.
4. Press the Start button on the screen. As the prints are made, mark each to indicate the
lead edge.
5. Take the third pattern that was printed and measure from the lead edge to point 'A' on
ure 1 (the intersection of the 7th line from the left edge and the first line from the lead
edge).
02/03
4-170
Entering Diagnostic
Fig-
Initial issue
DC 3535/2240/1632