8-631 Regicon Skew (Patch K)
During A1 Patch detection, skew deviation for K exceeded tolerance.
NOTE: Machine operation continues. Status Code not displayed on UI. Status Code logged in
History.
Initial Actions
Clean MOB Sensor.
Procedure
Check the IBT Belt and Drum for a scratch or contamination. The check is OK.
Y
N
Replace as required.
Adjust the Color Registration
(ADJ
9.6).
Initial issue
DC 3535/2240/1632
8-900 Static Jam
When the machine power is turned off then on before a paper path fault is cleared, an 8-900
fault will be displayed. A voltage drop or interruption can also cause this fault.
Initial Actions
•
Check the entire paper path for paper or obstructions.
•
Clean all the paper path sensors.
•
Check the Fault History for the last paper path fault. Go to that paper path fault RAP.
Procedure
In sequence, enter the following
dC330
Block and unblock each sensor
•
8-100 Tray 1 Mis-feed,
(7-105
•
8-106 Tray 2 Mis-feed,
(7-110
•
8-102 Tray 3 Mis-feed TTM,
(7-115
•
8-102 Tray 3 Mis-feed 3TM, (7-117RAP).
•
8-103 Tray 4 Mis-feed TTM,
(7-119
•
8-103 Tray 4 Mis-feed 3TM, (7-120RAP).
•
8-104 Registration Sensor,
(8-175
•
8-105 Duplex Transport Wait Sensor,
•
9-201 POB On Jam,
(8-164
RAP).
•
10-101 Fuser Exit Switch,
(10-111
The display for each code changes.
Y
N
Go to the appropriate paper path fault RAP.
Check the machine input voltage, if the problem continues, replace the ESS PWB
02/03
2-171
codes:
RAP).
RAP).
RAP).
RAP).
RAP).
(10-125
RAP).
RAP).
Status Indicator RAPs
8-631, 8-900
(PL
13.1).