Xerox DocuColor 2240 Service Manual page 146

Y N
Takeaway Motor 1 (PL 15.9) energizes.
Y N
Press Stop. +24 VDC is measured between P/J552-3 and GND on the Tray
Module PWB.
Y N
+24 VDC is measured at P/J 555-3 on the Tray Module PWB.
Y N
Refer to the +24 VDC Wirenets
Module PWB.
Replace the Tray Module PWB
+24 VDC is measured at each of the following pins on P/J552: Pin 1, 2, 5, and
6.
Y N
Refer to Figure 6. Check the wires from the Tray Module PWB to the Takeaway
Motor 1 for an open circuit. If the wires are good, replace the Takeaway Motor 1
(PL 15.9)
With [008-028] still entered, press Start and check that the voltage at
2, 5, and 6 each drop to approximately +22 VDC. The voltage at
5, and 6 all drop to approximately +22 VDC when [008-028] is entered.
Y N
Replace the Tray Module PWB
Replace the Takeaway Motor 1
Press Stop. Check the Takeaway Motor 1 and its associated gears
contamination and misalignment.
Press Stop.
• Check the Tray 2 Feed / Lift Motor and its associated gears
misalignment.
• Ensure that the Tray 2 Chute (PL 15.10) is properly seated and not damaged.
• Ensure that the connectors shown in the circuit diagrams (Figure) are securely connected
and that the wires are not damaged.
• If these checks are OK, replace the Tray Module PWB
Status Indicator RAPs
7-110
(Figure 5). Check the +24 VDC to the Tray
(PL 15.9).
P/J552
P/J552
(PL 15.9).
(PL 15.9).
(PL 15.9) for damage,
(PL 15.3) for damage and
(PL 15.9).
Figure 1 7-110 RAP Circuit Diagram - Takeaway Sensor (TTM)
pins 1,
pins 1, 2,
Figure 2 7-110 RAP Circuit Diagram - Tray 2 Feed/Lift Motor (TTM)
02/03
2-116
Initial issue
DC 3535/2240/1632