Xerox DocuColor 2240 Service Manual page 245

10-110 Fuser Exit Switch On (Duplex)
The Fuser Exit Switch did not energize.
Initial Actions
• Check condition and specification of the paper supply.
• Check for obstructions in the paper feed path.
• Clean the Fuser Exit Roll and check for wear.
• Check the drive transmissions for damage or wear.
Procedure
Remove the Fuser Assembly from the machine and check Check the Fuser Stripper Fingers
and Fuser Roll (PL 7.1) for dirt build up, wear or damage. The check is OK.
Y N
Clean or replace the Fuser Assembly
Open the Left Cover Assembly (PL 2.8). Enter
Fuser Exit Switch (PL 2.8). The display changes state.
Y N
Press Stop. Check the circuit of the Fuser Exit Switch
RAP for troubleshooting procedure.
Press Stop. Enter dC330 [008-037] and press Start. The Registration Clutch
gizes.
Y N
Press Stop. Check the circuit of the Registration Clutch
RAP for troubleshooting procedure.
Close the Left Cover Assembly and press Stop. In sequence enter the following:
052] then dC330 [009-051] and press Start. The 2nd BTR Retract Motor
and retracts.
Y N
Press Stop. Go to the 9-342 RAP for a contact failure or go to the
failure.
Press Stop.
• Ensure that the connectors shown in the circuit diagrams
connected and that the wires are not damaged.
• If the problem persists, replace the MCU PWB
Initial issue
DC 3535/2240/1632
(PL 7.1).
dC330 [010-101] and press Start. Actuate the
(Figure 1). Refer to the
(PL
(Figure 2). Refer to the
dC330
(PL 2.9) contacts
9-343 RAP for a retract
(Figure 1, Figure 2) are securely
(PL 13.1).
Figure 1 10-110 RAP Circuit Diagram - Fuser Exit Switch
OF 99-3
2.6) ener-
OF 99-4
Figure 2 10-110 RAP Circuit Diagram - Registration Clutch
[009-
02/03
2-215
Status Indicator RAPs
10-110