IQ7 Deletion RAP
Part of the image is missing.
Procedure
Check the paper type. Paper used is within specifications.
Y
N
Use paper within specifications.
Use paper from a freshly opened packet. The problem reoccurs.
Y
N
End
Remove the Drum Cartridge (PL 8.1) (REP 8.1.1) and reinstall it. Turn the power OFF then ON
and print. The problem reoccurs.
Y
N
End
Install the new Drum Cartridge (PL 8.1) (REP 8.1.1) securely. Turn the power OFF then ON
and print. The problem reoccurs.
Y
N
End
Check the surface of the BTR for distortion. There is no distortion on the surface of the
BTR.
Y
N
Replace the BTR Roll (PL 6.1) (REP 4.1.1).
Replace the ESS/MCU PWB (PL 18.3) (REP 18.3.2).
Image Quality Troubleshooting
3.1.4 Image Quality Troubleshooting
IQ8 Skew/Misregistration RAP
Printed images are not parallel to the edges of the paper.
Procedure
Check the location where the machine is installed. The machine is installed on a stable
level surface.
Y
N
Install the machine on a stable level surface.
Remove the Drum Cartridge (PL 8.1) (REP 8.1.1) and reinstall it. Turn the power OFF then ON
and print. The problem reoccurs.
Y
N
End
Check the installation of the Paper Cassette. The Paper Cassette is installed correctly.
Y
N
Install the Paper Cassette properly.
Check for distortion in the paper transport path. There is no distortion in the paper trans-
port path.
Y
N
Correct the distortion or replace the distorted part.
Replace the ESS/MCU PWB (PL 18.3) (REP 18.3.2).
06/2014
3-8
Version 1.0
WC 5022/5024