Table of Contents
Advertisement
may issue the command no max-metric router-lsa on-startup. The command
no max-metric router-lsa summary-lsa causes OSPF to send summary LSAs
with metrics computed using normal procedures defined in RFC 2328.
maximum-paths
Use the maximum-paths command in Router OSPF Configuration mode to
set the number of paths that OSPF can report for a given destination. Use the
no form of the command to reset the number to the default value.
Syntax
maximum-paths integer
no maximum-paths
•
integer — Number of paths that OSPF can report for a given destination.
(Range: 1–4.)
Default Configuration
4 is the integer default value.
Command Mode
Router OSPF Configuration mode.
User Guidelines
OSPF is only enabled on an interface if the primary IPv4 address on the
interface matches a network area range. Any individual interface can only be
attached to a single area. If an interface address matches multiple network
area ranges, the interface is assigned to the area for the first matching range.
If the ip ospf area command is given for an interface, it overrides any
matching network area command.
OSPF only advertises IP subnets for secondary IP addresses if the secondary
address is within the range of a network area command for the same area as
the primary address on the same interface.
When a network area command is deleted, matching interfaces are
reevaluated against all remaining network area commands.
Layer 3 Routing Commands
1668
Advertisement
Table of Contents
