Show Ip Ospf Traffic - Dell N1100-ON Reference Manual

User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
Example
The following example displays the OSPF stub table.
console(config)#show ip ospf stub table
AreaId TypeofService
------------- -------------
0.0.0.1

show ip ospf traffic

Use the show ip ospf traffic command to display OSPFv2 packet and LSA
statistics and OSPFv2 message queue statistics. Packet statistics count
packets and LSAs since OSPFv2 counters were last cleared (using the
ospf counters command.)
NOTE: Note that the clear ip ospf counters command does not clear the message
queue high water marks.
Syntax
show ip ospf traffic [vrf vrf-name]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default setting.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
Metric Val Import SummaryLSA
---------- -----------------
Normal 1 Enable
Layer 3 Routing Commands
clear ip
1706