Configure Interface Bundle Qos Add_Class - Avaya Secure Router 3120 Command Reference Manual

CONFIGURE
configure interface bundle qos class
configure interface bundle qos delete_all
configure interface bundle qos delete_class
configure interface bundle qos enable
applies to:
All modules

configure interface bundle qos add_class

This command creates a new QoS class.
The class_name, parent, cr, and br parameters must be entered; the other parameters are
optional. Optional parameters not entered during the creation of a QoS class may be entered
using the configure interface bundle qos class command.
Root-out classes are not supported.
parameter
class_name
parent
cr
cr_percent
br
br_percent
priority
298 Avaya Secure Router 3120 Command Reference Guide
next-level commands
The name assigned to a new QoS class.
The maximum number of characters allowed is 19.
Name of the parent class; QoS classes are defined hierarchically.
To add to the root, specify root-in or root-out.
Committed Rate (entered in Kbps).
Minimum value = 1 Kbps. Maximum value = interface bandwidth.
The sum of CRs of all classes at a specific level cannot exceed BR.
Supported for outbound traffic only.
Committed Rate as a percentage of interface bandwidth.
Valid Range(s) : 1 - 100
Burst Rate (entered in Kbps).
Minimum value = 1 Kbps. Maximum value = interface bandwidth or
the BR value of the parent class, whichever is lesser. BR >= CR for a
class. Supported for outbound traffic only.
Burst (Peak) Rate as % of interface bandwidth
Valid Range(s) : 1 - 100
Scheduling priority.
Valid only for leaf classes. The range is 1 - 8. Supported for outbound
traffic only.
definition
December 2010