Debug All - Avaya Secure Router 3120 Command Reference Manual

Chapter 6: DEBUG
The Router operating system includes a comprehensive suite of debug commands for use by network
administrators for network configuration and troubleshooting.
Note:
Debug commands are resource intensive. Because certain debug commands (such as arp) run in the
background, they consume system resources. Using these commands will impact system performance,
therefore they should be used with discretion. And, it is not advisable to run debug commands on a
system that is operating in a live network.
The first-level debug commands are as follows:
Table 15: Top-Level Debug Commands
crypto Accesses debug crypto commands.
dhcp_relay Accesses dhcp relay debug commands.
fr Accesses frame relay debug commands.
ip Accesses IP/IPmux debug commands.
lance Accesses Ethernet debug commands.
mhu Enables or disables Multi-Hospitality Unit (MHU) debug commands.
nat Enables or disables Network Access Translation (NAT) debug commands.
ppp Enables or disables Point-to-Point Protocol debug commands.
qos Enables or disables Quality of Service (QoS) debug commands.
rtp Displays debug information about Real-time Transport Protocol (RTP).
system Accesses system-level debug commands.
ttcp Accesses commands to configure the ttcp server and client.
vlan Accesses Virtual Local Area Network (VLAN) debug commands.

debug all

debug all
This command disables all current debugging.
Avaya Secure Router 3120 Command Reference Guide December 2010 573