Multicast Commands - Avaya Secure Router 3120 Command Reference Manual

MULTICAST COMMANDS

4 192.168.2.3 PIM
5 192.168.2.2 PIM
6 192.168.2.1 PIM
where:
4 192.168.2.3 – 192.168.2.3 is intermediate router 4 hops away from the destination PIM
thresh^ 0 Multicast Protocol in use on this hop and TTL Threshold. 674 ms is the time taken
to trace is to be forwarded between hops.
Note—In this release, Maximum Hops and TTL values can not be configured. Maximum Hops
is set to 32 and TTL is set to 127 in all mtrace packets as the default.
Multicast Commands
The following section explains the mutlicast mode and interface specific multicast mode
commands.
ip multicast
Enters the multicast mode.
syntax:
[no] ip multicast
example:
The following example enables IP multicast mode.
SR/configure/> ip multicast
SR/configure/ip/multicast>
applies to:
All modules
configure ip multicast multipath
Configures the router to do load splitting of multicast traffic over equal cost paths. By default,
multipath is enabled with Highest Random Weight (HRW) method. Use the no form of the
command to disable multipath. Enabling multipath without specifying the mode, enables
764 Avaya Secure Router 3120 Command Reference Guide
thresh^ 0 673 ms
thresh^ 0 674 ms
thresh^ 0 673 ms
December 2010