Configure Module E1 Circuitid - Avaya Secure Router 3120 Command Reference Manual

parameter
delta
syntax:
user number variable interval rising_threshold falling_threshold [sample type ] <cr>
example:
SR/configure/module/e1 (2/1-3)/alarms/thresholds> user 1 ses 300 50 30
In this example, the monitored parameter is the number of Severely Errored Seconds that
occur. The sampling interval is set to 300 seconds (5 minutes). The rising alarm threshold is
50 SES and the falling alarm threshold is 30 SES. Delta sampling is used (by default), in which a
rising alarm is reported if the SES count increases by 20 (50 - 30 = 20) during any sampling
interval. Similarly, a falling alarm is reported if the SES count decreases by 20 during any
interval.
applies to:
E1 module, serial modules that support v.35 or x.21

configure module e1 circuitId

This command specifies an optional circuit name to the E1 channel.
parameter
ckt_id
syntax:
circuitId cktid < name >
Note:
This command does not support the specifying of port ranges. Enter this command on a
port-by-port basis.
example:
SR/configure/module/e1 (2/1-3)> circuitId Main01
Avaya Secure Router 3120 Command Reference Guide
The errored second or event count is compared to the difference
between the rising and falling thresholds above, and a rising
alarm is reported if the actual error count exceeds that
difference. This is the default setting if you do not specify a
sampling type.
Optional circuit name for the E1 channel.
configure module e1 circuitId
definition
definition
December 2010 405