CONFIGURE
configure interface ethernet nat timeout
This command sets the NAT timeout interval for an Ethernet bundle.
Secure Routers are factory-configured so that all dynamic TCP translation entries that have
been inactive for two hours are deleted. Also, all dynamic UDP entries inactive for one minute
are deleted.
parameter
protocol_type
tcp
udp
seconds
syntax:
timeout protocol_type < tcp | udp > [ seconds < n > ]
example:
SR/configure/interface/ethernet 0/nat> timeout udp 3600
applies to:
All modules
configure interface ethernet nat trans_addr
This command adds or deletes the NAT translation port IP address for a specific Ethernet port.
parameter
ip_address
syntax:
[ no ] trans_addr ip_address < IP address >
example:
342
Avaya Secure Router 3120 Command Reference Guide
TCP protocol
UDP protocol
Number of seconds for timeout
The default for TCP is 7200.
The default for UDP is 60.
The valid range is 60 - 86400.
IP address of a translation port
definition
definition
December 2010