Configure Boot - Avaya Secure Router 3120 Command Reference Manual

CONFIGURE

configure boot

This command configures the boot file from flash.
parameter
file
syntax:
boot < file >
example:
SR/configure> boot sys.Z
applies to:
All modules
configure cabletype
This command selects the type of cable the E1 or monitor port will use.
parameter
e1_port
coaxial
twisted_pair
monitor_port
coaxial
twisted_pair
syntax:
cabletype [ e1_port < 1 | 2 > < coaxial | twisted_pair >] | [ monitor_port < 1 | 2 > < coaxial |
twisted_pair > ]
176 Avaya Secure Router 3120 Command Reference Guide
Boot up file name
The default is NCM.Z.
Specifies the slot number, either 1 or 2 .
Chooses coaxial cabling for the E1 port (impedance = 70 ohm).
This is the default.
Chooses twisted pair cabling for the E1 port (impedance = 120
ohm).
Specifies the slot number, either 1 or 2.
Chooses coaxial cabling for the monitor port (impedance = 70
ohm).
Chooses twisted pair cabling for the monitor port (impedance =
120 ohm).
definition
definition
December 2010