Configure Interface Ethernet Speed - Avaya Secure Router 3120 Command Reference Manual

configure interface ethernet speed

Sets the speed and operating mode of an Ethernet port.
parameter
speed
mode
syntax:
speed speed < 10 | 100 | auto > [ mode < full_duplex | half_duplex > ]
example:
SR/configure/interface/ethernet 0> speed 100 half_duplex
applies to:
All modules
configure interface ethernet track
This command accesses next-level commands for configuring tracking parameters.
syntax:
track
example:
configure/interface/ethernet 0> track
configure interface ethernet track hold_down
configure interface ethernet track interface
applies to:
Avaya Secure Router 3120 Command Reference Guide
Ethernet speed (10, 100 Mbps, or auto to automatically adjust
to the current Ethernet speed)
The default is auto.
Full-duplex (two-way transmission) or half-duplex (one-way
transmission)
The default is full-duplex. Enter this parameter only if you set
speed to 10 or 100 Mbps.
next-level commands
configure interface ethernet speed
definition
December 2010 361