Configure Interface Ethernet Nat - Avaya Secure Router 3120 Command Reference Manual

When a frame size larger than 1500 (jumbo frames) is configured, the system must be rebooted
for the change to take effect. For a frame size smaller than 1500, rebooting is not required for
the change to take effect.
Jumbo frames are Ethernet frames used to efficiently transfer bulk data. Both ends must
support and be configured for jumbo frames to use them.
mtusize
syntax:
mtu mtusize [ < n > ]
example:
SR/configure/interface/ethernet 0> mtu 4072
applies to:
All modules

configure interface ethernet nat

This command accesses next-level commands for enabling NAT on an Ethernet port and
accessing the associated NAT configuration commands.
Before using this command, make sure that the Ethernet is enabled.
syntax:
[ no ] nat
example:
SR/configure/interface/ethernet 0> no nat
configure interface ethernet nat address
configure interface ethernet nat enable
configure interface ethernet nat ip
configure interface ethernet nat ip max_entries
configure interface ethernet nat ip max_ports
configure interface ethernet nat pass_thru
Avaya Secure Router 3120 Command Reference Guide
parameter
next-level commands
definition
The configured size of the mtu
The range is 64 - 4072; the default is 1500.
configure interface ethernet nat
December 2010 337