Configure Interface Avc Red Wq_Bias_Factor - Avaya Secure Router 3120 Command Reference Manual

parameter
value
syntax:
tx_min_thresh value < n >
example:
SR/configure/interface/avc wan08 22/red> tx_min_thresh 4
configure interface avc red tx_max_thresh

configure interface avc red wq_bias_factor

applies to:
All modules
configure interface avc red wq_bias_factor
This command sets the weighting factor for the average queue size calculation.
A smaller value causes the average queue to follow the instantaneous value more closely.
Whereas, a larger value will cause the average value to change less rapidly and mask the
variations in the instantaneous queue size. A very low value of the wq_bias_factor can result
in unnecessary packet drops, and a very high value will not respond quickly enough to
congestion.
Router recommends that you do not change the wq_bias_factor value after setting it.
parameter
value
syntax:
wq_bias_factor wq_bias_factor value < n >
example:
Avaya Secure Router 3120 Command Reference Guide
The threshold at which RED begins dropping packets.
Setting the minimum threshold below 10 may cause
unnecessary packet drops.
The range is 1 - 511; the default is dependent upon the
bandwidth of the AVC.
The default setting is applied when a bundle is configured. To
check the default value, issue the show interface avc command.
related commands:
The weighting factor for the average queue size calculation.
The range is 3 - 20; the default is 5.
configure interface avc red wq_bias_factor
definition
definition
December 2010 199