Ip Igmp Query-Response-Interval - Avaya Secure Router 3120 Command Reference Manual

MULTICAST COMMANDS
General Queries. The Query Interval cannot be less than the Query Response Interval
(configured using ip igmp query-response-interval).
Use the no form of the configuration to return to the default value of 125 seconds. Note:
Specifying a value for time-seconds in the no form has no effect on the configuration.
syntax:
[no] ip igmp query-interval time-seconds?
parameter
time-seconds
example:
The following example configures the default Query Interval for the ethernet0 interface to be
60 seconds.
SR/configure/ip/igmp/interface ethernet 1/0> query-interval 60 SR/configure/ip/igmp/
interface ethernet 1/0>
applies to:
All modules

ip igmp query-response-interval

Configures the maximum amount of time before a Host sends a Report message in response to
a received General Query. This interval is encoded in the Max Resp Code field of General
Query messages.
Use the no form of the configuration to return to the default value of 10 seconds. Note:
Specifying a value for time-seconds in the no form has no effect on the configuration.
syntax:
[no] ip igmp query-response-interval time-seconds
parameter
time-seconds
754 Avaya Secure Router 3120 Command Reference Guide
a number in seconds between 0 and 3174
Note:
This value cannot be less than the Query Response Interval
1 and 3174 seconds
Note:
This value must be less than or equal to the Query Interval.
definition
definition
December 2010