Avaya Secure Router 3120 Command Reference Manual page 299

parameter
src_ip_address
dst_ip_address
netmask
port
vlan_id
dscp
dot1p
nat_ip
mark_dscp
mark_vlan
mark_dot1p
Each class can be configured using either explicit burst and committed rates or templates. The
syntax for these commands is :
syntax 1:
add_class class_name parent [ cr ] [ cr_percent ] [ br ] [ br_percent ] [ priority ] [ src_ip_address ]
[ dst_ip_address ] [ netmask ] [ port ] [ vlan_id ] [ dscp ] [ dot1p ] [ nat_ip ] [ mark_dscp ]
[ mark_vlan ] [ mark_dot1p ] <cr>
syntax 2:
add_class < class_name > < parent > cr < n > br < n > [ priority < n > ] [port < n >] [ vlan_id
< vlan id > ] [ dscp < n > ] [ nat_ip < nat_ip address > ] [ mark_dscp < n > ] [mark_vlan < n > ]
example:
SR/configure/interface/bundle SF_01/qos> add_class eng3 r
applies to:
All modules
Avaya Secure Router 3120 Command Reference Guide
Source IP address, range of source IP addresses, source subnet, or
(default) to which QoS parameters will apply.
Destination IP address, range of destination IP addresses,
destination subnet, or (default) to which QoS parameters will apply.
Subnet mask used to specify a source or destination subnet to which
QoS parameters will be applied.
Port number or (default) indicating which applications QoS
parameters will be applied to.
The VLAN ID number or range of VLAN ids to which the QoS
parameters will apply.
The range is 1 - 4095 or default.
DiffServ codepoint or a range of DiffServ codepoints to which the
QoS parameters will apply.
The range is 0 - 63.
802.2p priority. Valid range is 0-7.
Specifies a NAT translation address for this class
Marks all packets with a specific DiffServ codepoint
The range is 0 - 63.
Tags packets with specific VLAN id if tagging is enabled
Marks packets with 802.1p priority. Valid range is: 0-7.
configure interface bundle qos add_class
definition
December 2010 299