Configure Module E1 Enable - Avaya Secure Router 3120 Command Reference Manual

CONFIGURE
parameter
description
syntax:
description [description ]
Note:
This command does not support the specifying of port ranges. Enter this command on a
port-by-port basis.
example:
SR/configure/module/e1 (2/1)> xyzInc
configure module e1 alarms
configure module e1 clock_source

configure module e1 enable

configure module e1 framing
configure module e1 linemode
configure module e1 name
applies to:
E1 module, serial modules that support v.35 or x.21
configure module e1 enable
This command places an E1 link in service and allows the link to transmit and receive data.
To take an E1 link out of service, type no enable at the configure/module/e1> prompt. This
action sends an all-ones Alarm Indication Signal (AIS) to the far end and places the link out of
service.
To verify the in-service or out-of-service status of an E1 channel, use the show module
configuration e1 command.
syntax:
[ no ] enable
example:
408 Avaya Secure Router 3120 Command Reference Guide
Describes or names the E1 interface
next-level commands
definition
December 2010