Table of Contents
Advertisement
MULTICAST COMMANDS
ip pim join-prune-interval
Sets the frequency with which join/prune messages are sent (default: 60 seconds). Use the
no form of this command to set the default value.
syntax:
[no] join-prune-interval interval
parameter
time
example:
To send messages every five minutes, enter:
SR/configure/ip/pim> join-prune-interval 300
applies to:
All modules
ip pim mode
Configures the PIM router for sparse mode. Default is sparse-SSM mode.
syntax:
mode [sparse|dense]
parameter
mode
example:
To configure the router for sparse mode PIM, enter:
SR/configure/ip/pim> mode
applies to:
All modules
782
Avaya Secure Router 3120 Command Reference Guide
The frequency (in seconds) with which join/prune messages are
sent. Valid range is: 1— 65535 seconds.
The mode of PIM used on the router. Mode takes two options,
sparse to configure sparse mode, and dense which is not
supported in this release.
definition
definition
December 2010
Advertisement
Table of Contents
