Test E1 Loopback Inward2 - Avaya Secure Router 3120 Command Reference Manual

All modules

test e1 loopback inward2

This command configures an E1 interface for local inward 2 loopback.
The inward 2 loopback also loops back the signal going out to the network back into the
received signal, however, this loopback takes effect at the Framer.
syntax:
loopback inward2
example:
SR/test/e1 1/1> loopback inward2
test e1 loopback inward1
test e1 loopback inward1_analog
test e1 loopback line
test e1 loopback payload
All modules
test e1 loopback line
This command activates an E1 line loopback.
This loopback sends an incoming E1 signal back to a remote system for line testing.
syntax:
[ no ] loopback line
example:
SR/test/e1 1/3> loopback line
To verify loopback status during the test, use the show module test e1 command.
test e1 loopback inward1
Avaya Secure Router 3120 Command Reference Guide
related commands:
related commands:
test e1 loopback inward2
December 2010 921