SHOW
example:
SR/show/module/test> t1 1/1
Table 40: screen display example
>
show module test t1 1/1
Currently no tests are being run
Last Test Status:
No test has been run on this interface since reboot
>
show module test e1
show module test t3
applies to:
T1 module
show module test t3
This command displays the test status of a Clear Channel T3 interface.
If no test is in progress, the message "Currently no tests are being run" appears. This message
is followed by the status of the last test or loopback operation performed.
parameter
t3
t3_no
syntax:
t3 t3_no
example:
SR/show/module/test> t3 1/1
show module test t1
applies to:
876
Avaya Secure Router 3120 Command Reference Guide
related commands:
Clear Channel T3
The slot (1 or 2) in which the module is located. Port numbering
varies by module.
related commands:
definition
December 2010