Configuring Interface Ports - Avaya 3500 Series Getting Started

Configuring the switch using EDM

Configuring interface ports

Use the following procedure to configure one or more interface ports.
Before you begin
You must select one or multiple ports from the Device Physical View tab.
About this task
You can view and configure the configuration for the interface ports on the switch or stack.
Procedure
1. From the navigation tree, double-click Edit.
2. In the Edit tree, click Chassis.
3. In the Chassis tree, click Ports.
4. In the work area, click the Interface tab.
5. To select an interface port to edit, click a port row the Index column.
6. In the port row, double-click the cell in the Name column, type a character name.
7. In the port row, double-click the cell in the AdminStatus column and select a value from the
list.
8. In the port row, double-click the cell in the LinkTrap column and select a value from the list.
9. In the port row, double-click the cell in the AutoNegotiate column and select a value from
the list.
10. In the port row, double-click the cell in the AdminDuplex column and select a value from the
list.
11. In the port row, double-click the cell in the AdminSpeed column and select a value from the
list.
12. Repeat steps 5 through 11 to configure additional interface ports.
13. On the toolbar, click Apply.
14. To view and verify the current configuration, click Refresh.
Variable definitions
The following table describes configuring interface ports.
Variable
Index
Name
Getting Started with Avaya ERS 3500 Series
122
Value
Indicates a unique value assigned to each interface
port.
Specifies a name for the port.
Comments on this document? infodev@avaya.com
Table continues...
July 2015