Ip Pim Threshold-Rp - Avaya Secure Router 3120 Command Reference Manual

MULTICAST COMMANDS

ip pim threshold-rp

Specifies the threshold, in kilobytes per second, for a Rendezvous Point (RP), which, when
exceeded for an (S,G) pair, initiates a switch to the Shortest Path (SP) tree. If the dr-switch-
immediate option is configured, then configuring this option has no effect.
Use the no form of this command to return the value to the default of 1 KBps.
syntax:
[no] ip pim threshold-rp KBps
parameter
KBps
example:
To configure this router such that the data from S addressed to G must exceed an average of
1500 KBytes per second before an SPT switch is initiated, enter:
SR/configure/ip/pim> threshold-rp 1500
applies to:
All modules
ip pim whole-packet-checksum
Specifies that checksums in Register messages should be calculated over the entire
encapsulated data packet, rather than just over the Register message header.
If ip pim whole-pkt-checksum is not specified, it is the same as specifying no ip pim whole-pkt-
checksum.
syntax:
[no] ip pim whole-pkt-checksum
example:
To specify that the message checksum will be calculated over the entire encapsulated packet,
rather than just over the Register message header, enter:
SR/configure/ip/pim> whole-packet-checksum
applies to:
788 Avaya Secure Router 3120 Command Reference Guide
The threshold in bps. Valid Range is: 1—2147483.
definition
December 2010