Ip Pim Rp-Switch-Immediate - Avaya Secure Router 3120 Command Reference Manual

MULTICAST COMMANDS
parameter
address
group-address
group-mask
example:
To set the RP static IP address to 10.10.1.1, enter:
SR/configure/ip/pim> rp 10.10.1.1
applies to:
All modules

ip pim rp-switch-immediate

Causes a Rendezvous Point (RP) to initiate a switch to the Shortest Path (SP) tree for (S,G)
upon receipt of the first Register message encapsulating data from source S. The PIM-SM
protocol allows an RP or a Designated Router (DR) to switch from receiving data from a source
S sent to a group G via the RP tree, to receiving data from the SP tree. If this command is not
configured, then an active RP will initiate a switch to the SP tree when the traffic rate exceeds a
threshold. If this option is set, then any other options related to the default method of switching
will have no effect. Once this option is configured, the only way to return to the default mode
is to deconfigure it using the no form. This parameter is on by default.
syntax:
[no] rp-switch-immediate
example:
To turn on this feature, enter:
SR/configure/ip/pim> rp-switch-immediate
applies to:
All modules
ip pim ssm-range
Configures a range of multicast addresses to be treated as SSM group addresses. (Default is
232/8).
786 Avaya Secure Router 3120 Command Reference Guide
The static RP IP address.
The multicast group IP address.
The multicast group subnet mask.
definition
December 2010